Shopping Cart
Your shopping cart is empty!

NanoStation Loco M2

NanoStation Loco M2
NanoStation Loco M2
Product Code: NLM2
Availability: In Stock
Price: AU$175.00
   - OR -   

Ubiquiti NanoStation M2 LOCO (2.4GHz) Point-to-Point Wireless  & WiFi AP

Connect  two  remote locations  on the one network

Share Internet connection between buildings, remote sites,  etc Up to  200mW output  power, 2x2 MIMO operation, lOOMbps

Integrated AirOS web software for controlling power, bridge/ AP mode, etc. Includes POE inject or and 240V AC adapter

Two units required for wireless bridge

High Speed Point-to-Point Networking

Forget Ethernet cable, the Ubiquiti NanoStation LOCO is ideal for bridging networks or sharing broadband between buildings. To install, place the units at either  end of the network and connect  both to Ethernet  cables - for example, the first unit into your modem at location one,  and second into an Ethernet switch or WiFi access point at the other location. Face both units so they point towards each other and the link is established. Simple.

This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly  simple  - no routing  configuration, all protocols (DHCP, DNS, etc) just work. Management of the Ubquiti device couldn't be  easier with SSH and SNMP protocol support, as well as a very intuitive HTIP  interface.

802.l l b/g/ n WiFi Access Point

Login to the AirOS management software and set to AP mode to create a high performance WiFi network. With a wide directional broadcast angle the NanoStation LOCO is ideal for covering sports grounds and outdoor  areas by a sector-by-sector approach.

You can learn how to set up the NanoStation as a long range WiFi access point by following our guide here.

Ready to Install

This unit has all networking hardware and surge protection integrated and is compie tely weatherproof for permanent installation in even the toughest environmen ts. Signal strength indicators allow for quick and easy alignment. For best performance the unit should be roof mounted, high and clear of obstructions, via it's integrated pole mounting bracket .

The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation,  and the other  into the PoE Injector (which  is plugged into AC power). This allows one cable to both power the unit and also carry network traffic. We recommend using Cat6 Outdoor UV Shielded Cable  with  this unit.

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: